保定市电加热器厂

非固化电加热器特点:

Non curing electric heater features:

1. 采用3支800瓦耐干烧电加热管并联，整支电加热器功率为2.4千瓦（相当于一台家用空调机），对普通电源插座不形成压力，方便维修工程使用。

1. with 3 800 watts of dry heating pipe parallel, the entire electric heater power of 2.4 kilowatts (equivalent to a household air conditioner), the ordinary power outlet does not form pressure, convenient maintenance engineering use.

2. 底部采用法兰盘与带内牙的厚不锈钢管结合，可方便拆装更换配件，由于电加热管也有使用寿命，在损坏后可以更换，使得电加热器不再是一次性用品。

2. at the bottom of the flange and the thick stainless steel tube with the inner teeth, can be easily disassembled and replacement parts, because the electric heating pipe also has the service life, after the damage can be replaced, so that the electric heater is no longer one of the disposable supplies.

3. 使用耐高温硅橡胶电缆，可减少电缆的老化对电加热器造成的损坏。

3. the use of high temperature silicone rubber cable can reduce damage caused by aging of electric cables to electric heaters.

4. 底部电热管采用特殊形状，增加散热面积，使得非固化加热均匀，加热后桶内无残留。

4. the bottom electric heating tube adopts a special shape to increase the heat dissipation area, so that the non curing heating is uniform, and there is no residue in the barrel after heating.

5. 加热管底盘直径26厘米，适合绝大多数非固化包装桶。

5. the diameter of the heating pipe chassis is 26 cm, which is suitable for most of the non curing packaging barrels.

6. 加热效率高，经测定：加热至可涂刮状态耗时约22分钟，加热至可喷涂状态耗时约27分钟。

6. the heating efficiency is high. After measurement, it takes about 22 minutes to heat until it can be coated and scraped, and the time from heating to spraying can take about 27 minutes.

7. 若辅以外支架（选购件，可按图自行加工）后，可一人值守多支电加热器，提高了工作效率。

7. if auxiliary scaffolds can be processed according to the drawing, one person can watch many electric heaters and improve the work efficiency.

8. 外包装箱底部和顶部采用多层叠加，最大限度减少了运输途中可能造成的损坏。

8. the top and bottom of the outer packing box are stacked with multiple layers to minimize the possible damage during transportation.

使用主意事项：

Use of ideas:

1. 电源应带漏电保护功能，电源插座应按照电加热器所配置的插头提供。

1. the power supply should be equipped with leakage protection function. The power socket should be supplied according to the plug supplied by the electric heater.

2. 上部长杆为非热源段，但由于下部热量的传递，会有一定温度，应尽量避免触碰或把握，应手握橡胶把手进行操作。

2. the upper part of the long rod is a non heat source section, but due to the heat transfer of the lower part, there will be a certain temperature. It should be avoided or grasped as far as possible. The handle should be operated by hand.

3. 在多支同时使用时，一定要先确认电源有足够功率，不能确认时，可逐支增加，发现有跳闸或电源线发热的情形，应立刻减少使用数量。

3. when used at the same time, we must first confirm that the power supply has enough power. When it is not confirmed, it can be increased by one by one. It is found that there is a trip or the heating of the power line, and the amount of use should be reduced immediately.

4. 电加热管虽采用耐干烧的电阻丝，但长时间干烧也会影响其寿命，在连续换桶加热时应尽量减少中间暴露在空气中的停留时间，如确需长时间暴露停留，应暂时关闭电源或拔掉插头。

4. electric heating tube is resistant to dry burning resistance wire, but the long time dry burning will also affect its life. In the continuous change of bucket, the residence time of the middle exposure should be reduced as far as possible. If it is necessary for a long time to stay, the power or plug should be temporarily closed.

5. 如需更换配件，需由专业电工进行操作，并在更换配件后测量外壁的绝缘性能。

5. if you need to replace the fittings, you need to operate by professional electricians and measure the insulation performance of the outer wall after changing the accessories.

6. 本电加热器仅限于加热非固化，严禁用于加热水、油等其他介质。

6. this electric heater is only limited to heating non curing, and is strictly prohibited for heating other media such as water and oil.